Fluorocarbon insulation board _ one off decorative (certified) _ insulation off one plate from Shandong Decoration Engineering Limited. Shandong takeoff Decoration Engineering Company Limited (#) is Taian, granite leaders, over the years, the company is implementing scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In the off decorative leadership with the staff warmly welcome all inquiries negotiations to create a better future for takeoff decoration. Green ring exterior wall decoration panel system features: Features one: thermal insulation properties: decorative wall insulation board can play a cool effect one decorative insulation boards, building energy efficiency to meet the requirements of different regions. Features 2: energy saving and strong: the status quo of non-renewable resource generation for heating, played a lot of festival source effect. Features three: beautiful decorative excellent: surface using a self-developed new generation decorative coating green ring, rich colors, textures multiforme Tai'an one board insulation, impact resistance, good insulation whole board, not crack. Features four: easy maintenance: wall insulation decorative plates simple, safe and reliable one exterior insulation board, greatly reducing installation period, little affected by environmental factors. Features five: Use a wide range: applies to all "new construction" or "existing buildings." Rigid polyurethane foam is applied polyurethane synthetic material largest one, is generally divided into two components: A component (black material) isocyanate group B (white material) group insurance polyether. This product can be adjusted according to seasonal changes and produce user requirements. The company mainly produces all kinds of polyurethane insulation materials: wall insulation materials, cold spray coatings, pipe insulation materials, solar materials, refrigerator insulation materials, insulation material trunk, roof insulation materials, etc. ★ Casting combination of materials (A component) and PAPI (B component), the required weight ratio (A ratio of a ratio B = 1), with mechanical stirring time is 10-20 seconds at speed 1400 rev / min, immediately after the casting mold stir curing, the mold temperature at 30-40 ℃ the best ambient temperature at 15-20 ℃. (In accordance with an increase in density of the product feed) ★ sprayed spray foam more suitable temperature range is 15-35 ℃, preferably at ambient temperature 15-30 ℃. When the ambient temperature is low, the need heating, combination of materials shall not exceed 27 ℃. By spraying the surface should be free of rust, no oil, no dust, and require drying. Combination of materials each use, the rear should be used with stir tighten the lid to prevent moisture.