Insulation decorative board insulation decorative paste around what should be noted that one of the board should arrange construction program throughout the construction project, the follow-up project to avoid damage or contamination of insulation decorative panels. Before construction insulation decorative plate processing model should make one thin stone slab, after design, supervision and other units to confirm before construction. Here'll tell you about the basic situation: 1. Check processing grassroots, check the original exterior wall tile, no cracking (such as crack filling material is filled with a rigid solid), can not afford to powder, can not afford to sand, not hollowing (eg hollowing should knockout), no peeling, no lime bad bursting point and non-adhesive old coatings. During the construction of the wall in accordance with the design of vertical and horizontal reference line with the ink line on the wall shells. 2. The allocation of the required proportion of special adhesive mortar, the special powder binder added to the appropriate allocation of water with an electric mixer evenly, then start pasting insulation decorative panels, each painted dots diameter> 150mm, per square not less than eight meters spotting. Left seam between the board and the board 15mm, in order to adjust the installation errors. When installing decorative plates, left, up and down the deviation should not exceed 1.5mm. 3. insulation decorative plates pasted after the location you sure you want to install mechanical fasteners thin stone slab one phone, with self-tapping screws on the base. Anchors should start by the middle of the straight edge 300 ~ 500mm spacing install one thin stone slab, 6--8 per square meter, and then adjust the applied external pressure piece slab height difference when necessary. Anchors installed in the outer anchorage could not force too much thin stone one board address, in order to avoid damage to the plate surface. Material safety performance indicators system ⑴ construction site used to meet the requirements. ⑵ site pullout test compliance. ⑶ site management personnel should conduct random checks from time to time on the bond area, make sure to paste an area of ??not less than 60% of the board; do not meet the requirements of office, shall be re-finished plate ripped paste. (4) Construction weathering glue sealant should ensure uniform continuous, with the lap width of not less than the finished plate board surface 1mm. There should be no leakage after weathering plastic construction is completed. Respond when the board (5) board clean to check for defects or board painting appears damaged parts should be replaced. Thin stone decorative one board manufacturers _ takeoff (certified) _ one thin stone slab from Shandong takeoff Decoration Engineering Limited. Shandong takeoff Decoration Engineering Co., Ltd. (#) is Tai'an, granite leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In takeoff decorative leadership with the staff warmly welcome all inquiries negotiations to create a better future for takeoff decoration.